If your string breaks, it is usually a sign that it is a very old string (unless you turned the peg too tight). As the string usually breaks in the middle, the string is not long enough to put back on the violin again. It is not possible to reuse a broken string. That is why you always loosen the string a quarter-turn before tightening it again to tune the violin. If you turn the string higher than the target pitch, you risk breaking the string. The strings can only hold the tension of the target pitch. Violin strings usually break because you turned the peg further than the target pitch of the string. To tune the violin without breaking the strings, you must turn the pegs very slowly and carefully. How do you tune a violin without breaking the strings? That causes the peg to not stay in place in the peg box and to slip. The most common reason is that you are not pushing the peg into the peg box while you turn. If your pegs are slipping, it can have several reasons. New violin strings stretch and go out of tune for about two days until a week before they settle. There can be two reasons your violin keeps going out of tune: either you have brand new strings on your violin, or your pegs are slipping. In that case, you will have to turn longer than with a usual peg – keep turning the peg quickly until the string is close to the target pitch.įAQ Why does my violin keep going out of tune? Use the exact same technique described in my guide, but use the Wittner Finetune Pegs instead of the fine tuners.Ī common issue with the Wittner Finetune pegs is that if a string is loose or completely out of tune, it can take a long time to tune the string. To understand how to tune your violin with Wittner finetune pegs, please check out my guide “ How to Tune a Violin as a Beginner,” – in which I explain how to tune the violin with fine tuners. In practice, this type of peg works exactly like a fine tuner. Wittner pegs are a special type of violin pegs that have a gearing system within the peg. That is why for many professional violinists, tuning the violin with the pegs is the default way of tuning the violin. Therefore, the violin will sound a little bit better without the fine tuners. This is because the fine-tuners ever so slightly impact the sound of the violin. Many advanced players do not have fine tuners on the lower notes of the violin. The last step is tuning the A and the E string. After that, you continue to tune the D and the G string in the same way. If you are an advanced player, you can start by tuning the A string with a violin tuner or a tuning fork.Īfter that, you can play the D string and the A string at the same time until you hear that both notes form a perfect fifth. If you are a more advanced player, you can also tune the strings by ear. On the left side of your violin, you can find the tuning pegs for the D and the G string. When you first start learning to tune the violin with the pegs, it’s important to remember which peg belongs to which string.Īs you can see in the image below, on the right side of the violin, you can find the tuning pegs for the A and the E strings. Within it, you can see that each string is coiled around a tuning peg. The pegbox is the part of the violin that holds the tuning pegs. Below the scroll, you can see the pegbox. Next, look at the upper part of your violin. Step 3: Identify to Which String Each Peg Belongs In this way, you can easily pluck the strings. Step 2: Place the Violin on Your Kneeīefore you begin to tune your violin, place the violin on your knee. I recommend tuning with a tuning fork only to experienced musicians. You can also use a tuning fork if you would like to tune the violin by ear. If you use a violin tuning app or online violin tuner, make sure that you allow the app to use the microphone. Make sure to switch on the tuner if you use an electronic tuner. You can either use an electronic tuner or an online violin tuner.
0 Comments
Leave a Reply. |